4 号精整线于 9 月初完成安装调试并投入运行，主要承担薄料分条与拉丝前处理。
投产后分条月产能提升约 30%，最小条宽 8 mm，边部毛刺控制与卷取整齐度均优于原有产线。
薄料（0.3–0.8 mm）订单的交期由 18 天缩短至 12 天。
公司新闻 · 2026-09-05
No. 4 Finishing Line Commissioned, Slitting Capacity Up 30%
The newly built No. 4 finishing line has completed installation and commissioning, with a minimum slit width of 8 mm and a monthly capacity increase of about 30%.
Related Articles
行业资讯
2026-10-31
Laser Cutting 316L Dross: How to Match Nitrogen Pressure, Focus, and Speed
316L must be cut with nitrogen, not oxygen — but switching to nitrogen makes dross problems more common. Dross comes in two types, 'soft dross' and 'hard dross,' and the adjustment directions are exactly opposite.
View more news
行业资讯
2026-10-31
Stainless Steel Bending Springback: How to Set V-Groove, R/t and Rolling Direction
Stainless steel has much greater springback than carbon steel, so bending with carbon steel parameters will definitely give the wrong angle. Of the four variables that affect springback, two can be fixed at the time of ordering.
View more news
行业资讯
2026-10-31
Rust Spots on Stainless Steel Coils After Sea Shipment: Three Causes and Packaging Countermeasures
The idea that "the more expensive the steel, the more easily it rusts" in a container is not an illusion: drastic temperature and humidity changes at sea cause condensation, and the condensation water carries chloride ions. Most rust spots on arrival are not a material problem but a problem of packaging and container loading methods.
View more newsNeed a quote or samples?Provide material, thickness, width and quantity, and we will reply within 24 hours.
Contact Us
Related products and next step
One email a month: grade selection and market notes
The articles like this one, collected into a single email, with nickel price and lead-time movement. No blasts, unsubscribe anytime.