EN 10204 is a certificate type standard: it specifies what is written in the document and who signs it, not the material standard. So the phrase "we need EN 10204 3.1" is incomplete on its own — you also need to state the material grade and the governing standard (e.g. 316L / EN 10088-2).
Quick verdict
3.1 means the manufacturer inspects and signs for it themselves; 3.2 means manufacturer inspection plus an independent third party (inspection body or user-nominated representative) signs. When a project or end customer requires 3.2, substituting 3.1 is non-compliant; conversely, for general use 3.1 is sufficient and the extra third-party witness fee is unnecessary.
Practical differences between certificate types
- 2.2: declaration of conformity, no specific inspection results (no measured chemical composition or mechanical values). Generally used only for non-pressure, non-critical parts.
- 3.1: signed by the manufacturer's authorized inspector, supplied per batch with measured chemical composition and mechanical properties for that batch, traceable to the heat number.
- 3.2: builds on 3.1, with the inspection process witnessed and signed by a third party independent of the manufacturer (the third party can be an inspection company commissioned by the user, or the user's own resident representative).
In other words: the difference between 3.1 and 3.2 is whether anyone witnessed the inspection, not whether the data is accurate. Many projects treat the two as a "grade level", but the choice should really be based on consequence of failure: pressure-bearing, flammable/explosive, and safety parts need 3.2; general structural and decorative parts are fine with 3.1.
What to check when purchasing
When you receive the certificate, don't just look at the words "3.1" — check item by item:
- Heat number consistency: the heat number on the certificate must match the marking/label on the steel — this is the most common point of fraud (the certificate is genuine, but the goods are not from that heat);
- Measured chemical composition: not the standard range, but the measured values, and they must fall within the range; focus on C (316L requires ≤ 0.03%), Ni, Cr, Mo;
- Mechanical properties: yield, tensile, elongation; if impact requirements apply, also check the test temperature;
- Heat treatment condition: for stainless steel, state clearly whether solution-annealed/annealed — the same grade in different conditions can differ greatly in corrosion resistance;
- Signing entity: for 3.1, check whether it is the manufacturer's authorized inspector; for 3.2, check whether the third-party body is the one approved by the user;
- Standard number: EN 10204 is the certificate standard, and the material standard must also be stated (e.g. EN 10088-2 / ASTM A240).
Common pitfalls
- The project requires 3.2, but the supplier provides 3.1 and says "the content is the same" — the content may be the same, but the witnessing entity is different, and the supervisor will not accept it;
- The third-party stamp is the trader's own inspection company, not a body approved by the user;
- Photocopies/scans are used instead of originals, with no page-seam stamp and no verification method;
- Only the certificate is checked, not the physical steel stamp — if goods and certificate don't match, there is no way to hold anyone accountable.
We can supply EN 10204 3.1 material certificates with each batch (including measured chemical composition and mechanical values, traceable heat number), and can also arrange 3.2 witnessing with a third party you designate — to decide which one you need, send us the project's material standard and acceptance clauses first.
