ss-custom-waterjet
Waterjet Cut Stainless Parts
Waterjet Cut Stainless Parts · Grade on request · Thickness 1–100 mm · Width ≤ 3000 mm · Surface on request
on requestGrade
1–100 mmThickness
≤ 3000 mmWidth
on requestFinish
Available specification
| Grade | Thickness | Width | Finish | Standard |
|---|---|---|---|---|
| on request | 1–100 mm | ≤ 3000 mm | on request | To drawing |
Ranges shown are standard availability; non-standard sizes can be made to order. Thickness is nominal — tolerance judged to ASTM A480 / EN 10088-2, tighter classes on request.
Supply and service
- EN 10204 3.1 mill test certificate with every shipment (heat number and chemistry).
- Decoiling, slitting, cutting and circle blanking available — supplied to drawing.
- FOB / CIF / CFR quoting; third-party inspection (SGS / BV / Intertek) before loading.
Need a quote or technical support?
Send the size, quantity and destination port — FOB / CIF quote within 24 hours.
Typical applications
Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.
- Thick shaped parts — flanges and connection plates from 20–80 mm
- Heat-sensitive parts — precision parts that must not distort
- Laminates and stacks — stainless cut together with other materials
- Food and medical equipment — cut faces with no heat-affected zone
Selection FAQ
- Waterjet or laser?
- Laser for sheet up to about 12 mm and tight tolerance — faster, narrower kerf. Waterjet for thick plate, heat-sensitive parts, and where a heat-affected zone is unacceptable.
- How rough is the waterjet cut face?
- Typically a matte finish around Ra 3.2–6.3. Slower cutting gives a smoother face at higher cost.