Stainless steel
Hot Rolled Stainless Coil
No.1 annealed and pickled hot rolled coil in 304 / 316L / 2205 — 3–12 mm, width up to 1500 mm.
3–12 mmThickness
≤ 1500 mmWidth
Available specification
| Grades | Thickness | Width / diameter | Standard |
|---|---|---|---|
| 304 · 316L · 2205 | 3–12 mm | ≤ 1500 mm | ASTM A240 / EN 10088-2 |
Ranges shown are standard availability; non-standard sizes can be made to order. Thickness is nominal — tolerance judged to ASTM A480 / EN 10088-2.
Typical applications
- Structural and support members
- Tank shells and large vessels
- Substrate for further cold rolling
Delivery and inspection
- Fully annealed and pickled, acid residue rinsed — residual acid shows up as rust lines months later
- Passivation record available on request
- Edge condition: mill edge or trimmed
Need a quote or technical support?
Send the grade, size, quantity and destination port — we reply with FOB / CIF within 24 hours.
Typical applications
Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.
- Chemical plant — tank shells, reactor jackets, pipe supports
- Water and environment — waste water basin liners, desulphurisation towers, desalination lines
- Industrial structures — walkways, silos, conveyor frames
- Power — flue ducts, heat recovery units
- Further processing — feedstock for cold rolling, or decoiled into plate
Selection FAQ
- Can No.1 finish be used as-is?
- Yes, but it is grey and rougher. Visible structural parts are usually pickled or brushed afterwards.
- Hot rolled or cold rolled coil?
- Thicker material (generally above 3 mm), strength first, appearance secondary — hot rolled. Thin gauge, tight tolerance, good surface — cold rolled.
Not sure which grade fits? Use the grade selector