Stainless steel
Slit Stainless Strip
Slit strip in 304 / 316L / 430 — width from 8 mm, thickness 0.3–3 mm, burr controlled for stamping.
0.3–3 mmThickness
8–1500 mmWidth
Available specification
| Grades | Thickness | Width / diameter | Standard |
|---|---|---|---|
| 304 · 316L · 430 | 0.3–3 mm | 8–1500 mm | ASTM A240 / EN 10088-2 |
Ranges shown are standard availability; non-standard sizes can be made to order. Thickness is nominal — tolerance judged to ASTM A480 / EN 10088-2.
Typical applications
- Narrow stamped parts
- Tube and pipe making
- Hose clamps and fasteners
Delivery and inspection
- Burr height ≤ 0.05 mm on request (matters for high-speed stamping)
- Edge condition: slit or deburred
- Note: below 100 mm width the trim loss reaches 3–5% — we quote the yield
Need a quote or technical support?
Send the grade, size, quantity and destination port — we reply with FOB / CIF within 24 hours.
Typical applications
Below is where this material actually ends up — the specific parts, not just the industry. Compare it with your own service conditions, or send us the environment and we will advise.
- Tube making — welded tube, decorative tube, heat exchanger tube strip
- Stamping — cookware, locks, hardware blanks
- Cable tray and brackets — continuous roll-formed strip
- Automotive — clamps, trim strips, seal carriers
- Electronics — spring contacts, shields, battery shells
Selection FAQ
- What is the narrowest slit width?
- 8 mm is standard. Narrower needs an assessment of edge burr and coil winding quality — tell us the application when enquiring.
- What burr height do you hold?
- Within 0.05 mm as standard. For stamping or blanking, tighter limits can be agreed in the order.
Not sure which grade fits? Use the grade selector